b'Beckson Port Installation $ All Prices in 249Canadian Dollars $All Weather Non-Skid Step Pads Opening PortsModel# SM-1B Pair - Black $ 17.95/pr The Rain DrainModel# SM-1BR Pair - Brown 17.95/pr The Raid Drain opening port is designed primarily for installation where cabin sides have excessive Model# SM-1W Pair -White17.95/pr angles and other ports would collect rain and spray. These ports have all the features of Beckson\'s patented ports, with the addition of the patented Rain Drain. The Rain Drain port, cut at 5/8", will drain while tipped up to 45 degrees. Unlike others, Beckson Rain Drain Ports have open drains which resist clogging and are easy to clean.Other drain windows retain up to one- third of a cup of water in each window when closed.Opening them can soak you and the boat. Where greater mounting angles exist, insist on Beckson Rain Drain ports for superior service.We have 5 of these on HMP and are very pleased with these ports-PeterAll ports are available in the following colors.You may specify white frame or black frame.Clear lens orSpigotMax. Drain smoked lens. Length AngleAll ports are raindrain ports with 2" spigots. 5/8" 451" 40Beckson Port Gasket Installation Instructions. 1-1/2" 32Please read instructions carefully. Remove old gasket by pulling out of2" 24groove. Before installing a new gasket make sure groove is clean and dry. Do not use any type of lubricant and make sure the screen is in place, smooth side facing toward you and leg down into inner groove, before installing the new gasket.The part of the gasket that fits into the groove is the smaller, thinner part which is called the "leg". Start in between the two hinges by positioning the seam of the gasket over the outer groove of the window frame. Work from this location toward the top right comer. Guide entry of the leg of the gasket into the outer groove with your hand by bending the gasket out and away from the frame 90 deg.Pushing down firmly at the 90 deg point with your index finger or thumb will seat the gasket into the groove. Proceed slowly, seating 1/4" at a time. As you work around the corners, slightly stretch the gasket so extra material doesn\'t cause a crease or a bump. After seating the gasket around the first corner by hand, take the end of a wooden ruler or similar tool with a dull flat end and press down on top of the leg of the gasket to complete seating the first corner. This is accomplished when the small ribs on the leg of the gasket are completely inserted into the groove. Continue on to the following corners in the same manner until the gasket. is completely seated in the groove. Seating the last comer will require slight stretching of the gasket. If the gasket pulls out of the opposite corner, this indicates you need to go back to that corner and stretch the gasket a little more along with pushing it down into the groove further.Take extra care to make sure the leg is completely seated near the hinges and latches.The complete gasket should now be smooth and uniform.Note: These gaskets require some effort to install. A tight installation assures a water tight seal.email: hmp@hollandmarine.comwebsite: www.hollandmarine.comfax:905-891-7972tel:905-891-1639 249'