b'244 $ All Prices inBeckson Port InstallationCanadian Dollars $All ports are available in the following colors.You may specify white frame or black frame.Clear lens or smoked lens. All ports are raindrain ports with 2 spigots.Beckson Port Gasket Installation Instructions. Please read instructions carefully. Remove old gasket by pulling out of groove. Before installing a new gasket make sure groove is clean and dry. Do not use any type of lubricant and make sure the screen is in place, smooth side facing toward you and leg down into inner groove, before installing the new gasket.The part of the gasket that fits into the groove is the smaller, thinner part which is called the leg. Start in between the two hinges by positioning the seam of the gasket over the outer groove of the window frame. Work from this location toward the top right comer. Guide entry of the leg of the gasket into the outer groove with your hand by bending the gasket out and away from the frame 90 deg.Pushing down firmly at the 90 deg point with your index finger or thumb will seat the gasket into the groove. Proceed slowly, seating 1/4 at a time. As you work around the corners, slightly stretch the gasket so extra material doesnt cause a crease or a bump. After seating the gasket around the first corner by hand, take the end of a wooden ruler or similar tool with a dull flat end and press down on top of the leg of the gasket to complete seating the first corner. This is accomplished when the small ribs on the leg of the gasket are completely inserted into the groove. Continue on to the following corners in the same manner until the gasket. is completely seated in the groove. Seating the last comer will require slight stretching of the gasket. If the gasket pulls out of the opposite corner, this indicates you need to go back to that corner and stretch the gasket a little more along with pushing it down into the groove further.Take extra care to make sure the leg is completely seated near the hinges and latches.The complete gasket should now be smooth and uniform. Note: These gaskets require some effort to install. A tight installation assures a water tight seal.New Gaskets The gasket you take out of your port is rectangular like the gasket in the right. The round gasket you have purchased will look wrong, but actually, all gaskets start out round. Its a matter of feeding the leg of the gasket into the groove in the frame. Once it is installed it will be compressed flat to provide a waterproof seal.Old Compressed Gasket New Uncompressed GasketNewOld244 email: hmp@hollandmarine.comwebsite: www.hollandmarine.comfax:905-891-7972tel:905-891-1639'