b'474 $ All Prices inPaintCanadian Dollars $Pettit Protect High Build Epoxy For prevention and repair of gelcoat blistering.This is an excellent water barrier.Being a high build epoxy, means less coats for protection.Normally two (to three) coats is recommended. #4700/47011 quart kitGray $ 74.99 #4700/4701/G1 gallon kit Gray174.99OSMOSIS PREVENTION AND CURE4700/4701 Pettit Protect High Build Epoxy Primer The last step in the gelcoat blister repair system is the application of the final barrier, Pettit 4700/4701 High Build Epoxy Primer over the sealed and faired fiberglass laminate. For prevention of osmosis on new or unblistered hulls, the removal of the gelcoat, sealing and fairing is not required, and therefore application of the High Build Epoxy Primer is the first step. Regardless of which system you require, the application of the final epoxy barrier will be the same. Multiple coats are required (usually 2 or 3) until a dry film thickness of 18 mils (eighteen thousandths of an inch) is reached. Each coat may be applied in succession after the preceding coat has cured to a gel stage. After the final coat has reached the gel stage, the antifouling paint may be applied. Following this procedure will eliminate the need for sanding between coats, greatly reducing time and labour.#6149 Pettit Undercoater quart $ 57.99 105 White Undercoater is a high-filling, easy sanding marine type undercoater designed for use on wood and fiberglass surfaces. Provides a smooth base that allows Z*Spar Enamel to dry to a uniform gloss and appearance.Do not use below the waterline.7125 Glazing CompoundThis compound is made from a tough, plastic vehicle which dries rapidly for refinishing. Number 7125 is basically intended for a thin film glazing operation over fine, minor abrasions and blemishes where theimperfections are very shallow and small, no more than 1/8 in depth.It can be used on wood, metal and fiberglass. #2 White Glazing Putty (semi-paste)29.99/qtMarine Epoxy Repair Compound EZ-Tex is an easy to use marine epoxy repair compound for use where a high strength, waterproof, permanent repair is needed. This unique formula creates a tenacious bond to most surfaces. Its buttery consistency will not sag or shrink and is excellent for filling cracks, gouges and voids. A 1:1 ratio makes mixing easy. EZ-Tex can be sanded, drilled, tapped, sawed and painted once cured. - Easy to use 1:1 mix ratio repair compound for cracks, gouges, voids and holes - High strength formula makes repairs permanent - 100% waterproof when cured - Can be used above and below the waterline# _7100 4oz $ 27.99 - Will not sag, shrink or run # 7100-16oz 16oz $ 59.99474 email: hmp@hollandmarine.comwebsite: www.hollandmarine.comfax:905-891-7972tel:905-891-1639'